Supports low voltage devices with Vcc as low as 1.2v.
Device categories supported include memory devices,
microcontrollers, and logic devices.
Supports standard DIP or skinny DIP packages from 8 to 48-pins
on standard equipment
Supports a wide variety of SMD packages such as PLCC, SOIC,
TSOP, TQFP, QFN, etc., with reliable factory-made SMD adapters.
Free software updates can be downloaded via Internet at any time.
Round-robin (Concurrent) Programming Mode
This gang programmer is made up of four independent programming modules.
The programmer works in the round-robin mode versus the parallel mode
in traditional gang programmers.
In round-robin mode, the programmer starts
programming as soon as a device has been inserted into the first
programming site. By the time the operator finishes putting in the
device at the last site, the first site may have already finished
programming (depending on device programming time) and he can start
unloading/reloading at the first site.
Round-robin mode increases programmer throughput and
operator efficiency.
In over 95% of cases, our round-robin 4-site
gang programmer gives better programmer throughput than
an 8-site traditional parallel gang programmer.
Ultra fast programming speed is achieved by utilizing a local high speed
ASIC processor in each programming module of the programmer.
Programs high-density flash memory devices at near-theoretical
maximum programming speed.
Programs and verifies a 64M-bit NOR flash memory in 11.3 seconds
and a 1G-bit NAND Flash in 108 seconds.
Advanced Programmer Hardware
Advanced hardware design provides clean signals and
allows programming of low-voltage devices reliably.
Each one of the four programming modules has enough universal
pin-drivers to support large complex devices, up to 144-pins.
Since each pin-driver is software programmable, proper voltage
levels will be applied to each and every pin, not just the Vcc pins,
allowing true low-voltage programming for low-voltage devices.
Reverse insertion check and pin continuity check help to
prevent devices from accidental damage.
Over-current and over-voltage protection ensures safety of the
devices and programmer hardware.
Easy-to-use Programmer Software
Programmer-control S/W supports XP / Vista / Windows 7.
User-friendly software allows you to do these and more easily:
Read data from a master chip, put it in the data buffer
Save the data info t file
Program new chips with this data
Erase used EE chips before program them
Secure the chips so that others cannot copy from them
Load data from a file instead of from a master chip
The Auto-program command allows you to
erase the chips, blank-check them, program them, and
verify them, all automatically with just one click.
The Project function simplifies operations for
your production people or yourself.
Settings such as device selection,
file name selection, device configuration, program options, etc.,
can be saved into project files.
GANG PROGRAMMER SPECIFICATIONS
DEVICE SUPPORT
Device Types Supported:
EPROM, Paged EPROM, Parallel and Serial EEPROM, FPGA Configuration
Serial PROM, FLASH Memory (NOR and NAND), Bipolar PROM,
NOVRAM, SPLD, CPLD, EPLD, Firmware HUB,
Microcontroller, Microchip PIC, MCU, Standard Logic, etc.
Device Packages Supported on Standard Equipment:
DIP, Skinny DIP.
Programmer adapters for different SMD device packages.
WARRANTY
2-years. Programmer is warranted to be free of manufacturing
or workmanship defects for two (2) years from the date of purchase.
Warranty covers parts, labor, and free UPS ground shipping from
Advin back to customer. (Free ground shipping applies to 48-states
and Canada only).
Cart
Buy 5004GP Gang Programmer 
